Toshiba e-STUDIO556 Service Manual page 997

Sub
05/08 Mode Element
element
05 Adjustmen Process Image
t mode quality
control
05 Adjustmen Process Transfer Temperature/humidity
t mode sensor
05 Adjustmen Process Transfer Temperature/humidity
t mode sensor
05 Adjustmen Process Image
t mode quality
control
05 Adjustmen Process Image
t mode quality
control
05 Adjustmen Process Image Laser power
t mode quality adjustment
control
05 Adjustmen Process Image Laser power
t mode quality adjustment
control
05 Adjustmen Scanner Scanner
t mode
05 Adjustmen Scanner Scanner Image location
t mode adjustment
e-STUDIO556/656/756/856
Item Subitem Code
2188
2192
2194
2196
2198
2250
2250
3009
3030
Sub- Default Acceptable
Details
code value value
Image quality open- -
loop control
enforcement
Humidity display 60 0-100
Temperature display 22 0-50
Latest value of drum 22 0-100
temperature
Relative humidity 55 0-99
display at image
quality closed-loop
control
0 1st laser Refer to 0-255
contents
1 2nd laser 101 0-255
Log table switching 0
for RADF copying
(color)
Primary scanning 113 0-255
direction (scan.
section)
3
RAM Contents
M When a service call has occurred or a warning
message (IQC/SPC) has appeared, "Image quality
control enforcement (05-2120)" should be performed
after the equipment is repaired or the cause of the error
is evaluated. In case the service call occurred or the
warning message (IQC/SPC) appeared again after the
performance of the code 05-2120, a test chart can be
printed out by temporarily using this code (05-2188) if
an image check is urgently needed.
M The humidity of the inside of the equipment is
displayed.[Unit: RH%]
M The temperature of the inside of the equipment is
displayed.[Unit: °C]
M A drum surface temperature detected at the drum
surface potential sensor control is displayed.
M A relative humidity detected at the image quality
closed-loop control is displayed.
M When the value increases, the laser power output
increases.
<Default value>
e-STUDIO556/656: 132
e-STUDIO756/856: 101
M When the value increases, the laser power output
increases.
Valid only for e-STUDIO756/856
0-4 SYS 0: Same log table as the one used at copying with
original glass
1: Background reproduction - Light 2
2: Background reproduction - Light 1
3: Background reproduction - Dark 1
4: Background reproduction - Dark 2
SYS When the value increases by "1", the image shifts by
approx. 0.0423 mm toward the front side of the paper.
Proc Service
edure UI
6
2 Yes
2 Yes
2
2
14 Yes
14 Yes
1
1 Yes