Toshiba e-STUDIO556 Service Manual page 273

Note:
To secure the clutches (CLT2 [1] and CLT3
[2]), be sure to insert their stoppers to the
metal plates.
4.10.9 Horizontal transport section driving clutch-1 (CLT1)
(e-STUDIO556/656/756/856)
(1) Take off the transfer/transport unit.
( P.4-106 "4.10.5 Transfer/Transport unit")
(2) Disconnect 1 connector.
(3) Remove 1 E-ring and 3 screws to take off the
bracket.
(4) Take off the driving clutch from the shaft.
Note:
Fix the stopper of the clutch in the "R"
marked side.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
[1]
Fig. 4-305
Screw
Fig. 4-306
Horizontal transport section
driving clutch-1
Black
Fig. 4-307
e-STUDIO556/656/756/856/557/657/757/857
4 - 109
[2]
Bracket
Screw
E-ring
DISASSEMBLY AND REPLACEMENT
4