Toshiba e-STUDIO556 Service Manual page 548

7.8 Maintenance Part List
The parts used for the maintenance of this equipment are as follows.
No.
1 Door switch jig
2 Cleaning brush
3 RADF position pin
4 Wire holder jig
5 Belt tension jig
6 Downloading jig (K-PWA-DLM-320)
7 ROM
8 Downloading JIG (PWA-DWNLD-JIG1)
9 Downloading JIG (PWA-DWNLD-JIG2)
10
ROM writer adapter (For 1881)
11
ROM writer adapter (For 1931)
12 Patting powder
13 Drum bag
14 Color test chart (TCC-2)
15 Color test chart (TCC-3)
*1: Part list <P-I> represents the page item in (e-STUDIO556/656/756/856, e-STUDIO557/657/757/857
Service Parts List).
e-STUDIO556/656/756/856/557/657/757/857
PREVENTIVE MAINTENANCE (PM)
Item
7 - 38
Purpose
Lock of door switch
Cleaning inside of the equipment
Determining the position of the RADF
Fixing the wire at the assembly of the
carriage wire
Adjusting the belt tension at the
installation of the scan motor
Updating the scanner/options ROM
Installing the DLM board
Updating the system ROM
Updating the system ROM)
Writing the data of PWA-DWNLD-JIG1/
JIG2
Writing the data of PWA-DWNLD-JIG1/
JIG2
For Drum
Storing the drum
For test print (A4/LT)
For test print (A3/LD)
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Parts list
P-I*
201-1
201-2
201-4
201-5
201-7
202-1
202-2
202-4
202-5
202-2
202-4
202-5
202-2
202-4
202-5