Toshiba e-STUDIO556 Service Manual page 228

[ 2 ] Tandem LCF end fence motor (M42)
(1) Remove 1 E-ring and take off 1 bushing.
(2) Disconnect 1 connector, remove 3 screws
and take off the motor with the bracket.
Note:
When assembling, wire the harness and fix it
with filament tape as shown in the figure.
(Be sure not to wire it on the side of the
motor.)
(3) Release 2 gear latches and remove the gear.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Fig. 4-177
Harness
Filament tape
Motor
Fig. 4-178
Latch
Fig. 4-179
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 64
Tandem LCF
end fence motor
Bushing E-ring
Harness
Motor
Gear