Toshiba e-STUDIO556 Service Manual page 282

(4) Remove 2 E-rings, 2 washers, and 2 one-
way bearings. Then take off the web pushing
roller.
Notes:
1. When assembling the unit, be sure that
the one-way bearings are in the correct
directions.
2. Be sure that the web pushing roller rolls
only in the direction of the arrow in the
figure.
Notes:
1. When replacing the cleaning web, make
sure to attach the pin.
2. The remaining portion of the cleaning
web can be checked from the small
square hole of the fuser unit.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Washer One-way bearing
Mark side
Web pushing roller
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 118
One-way bearing
Mark side Washer
Fig. 4-328
Pin
Fig. 4-329
Full
Low
Fig. 4-330