Toshiba e-STUDIO556 Service Manual page 413

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO556:

Perform the same procedure for all paper sources.

When paper thinner than specified is used, paper jams may occur frequently at the registration

section. In this case, it is advisable to change (or reduce) the aligning amount.

However, if the aligning amount is reduced too much, this may cause the shift of leading edge

position. So, when adjusting the aligning amount, try to choose the appropriate amount while

confirming the leading edge position is not shifted.

* As a tentative countermeasure, the service life of the feed roller can be extended by

increasing the aligning amount.

e-STUDIO556/656/756/856/557/657/757/857