Toshiba e-STUDIO556 Service Manual page 325

(3) Remove1 E-ring and 1 bushing.
(4) Disconnect 1 connector.
(5) Remove 3 screws and take off the original
feed motor bracket with the motor.
Note:
When installing the original feed motor
bracket, refix the loosened screw and tighten
the belt tension.
4.13.28 Read motor (MR2)
(1) Take off the RADF rear cover.
( P.4-136 "4.13.3 RADF rear cover")
(2) Loosen 1 screw.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Bushing
Fig. 4-455
Fig. 4-456
Fig. 4-457
e-STUDIO556/656/756/856/557/657/757/857
4 - 161
E-ring
Connector
DISASSEMBLY AND REPLACEMENT
4