Toshiba e-STUDIO556 Service Manual page 859

8. Replace the equipment.
9. Turn the power ON while pressing [0] and [8] simultaneously.
10.Key in [3840], and then press the [START] button.
11. Press the [INSTALL] button.
12.Install the one-time dongle in the equipment (the one which you used for returning the selected
license before replacing the equipment). Then press the [OK] button.
13.Select the license to be installed, and then press the [INSTALL] button.
14.The screen for notifying that the installation will be started is displayed. Then press the [YES] button.
15.After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [NO] button. Then check that the one-time dongle is
installed properly in the equipment.
16.Check that the installed license is displayed on the license list.
Remark:
If there are any other licenses to be installed, repeat from step (11). If there are no other licenses
to be installed, press the [CLOSE] button, and then turn the power OFF.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856/557/657/757/857
REPLACEMENT OF PC BOARDS / HDD
9 - 41
9