Toshiba e-STUDIO556 Service Manual page 277

4.11 Fuser Unit
Notes:
When assembling or disassembling the fuser unit, be careful of the following items to avoid the
harnesses catching or other problems:
1. When installing the stay, be sure not to catch the harness on the screw or the driver.
2. Be sure that the harness is fixed with the clamp and it is not protruding out of the stay.
3. Connect the drawer connector securely. Wire the harness by passing it through the clamp as
shown in the figure.
4. Be sure that the harness of the web detection sensor is arranged within the stay as shown in
the figure, and that it is not sagging.
5. Be sure that you arrange the harness of the pressure roller thermistor while bypassing the
shaft as shown in the figure.
6. Be sure that the harness of the web motor runs through the harness clamp.
7. When installing the fuser unit cover (front), be sure not to catch the connector of the web
motor.
( 1 )
Screw
Stay
Harness
( 3 )
Harness clamp Harness clamp
( 5 )
Harness clamp
Harness
Shaft
( 6 )
Web motor
Harness clamp
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
( 2 )
Connector
Connector
Fig. 4-316
4 - 113
Harness clamp Harness clamp
( 4 )
Web detection sensor
Harness
( 7 )
Connector
Fuser unit cover (front)
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
4