Toshiba e-STUDIO556 Service Manual page 229

(4) Remove 3 screws and take off the tandem
LCF end fence motor.
[ 3 ] Tandem LCF end fence solenoid (SOL8)
(1) Remove 4 screws and take off the bracket.
(2) Remove 1 screw and take off the tray-up unit
side wall.
(3) Remove 2 screws, disconnect 1 connector,
and take off the tandem LCF end fence
solenoid.
[ 4 ] Tandem LCF bottom sensor (S71)
(1) Remove 2 screws and take off the plates.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-180
Bracket
Tandem LCF
end fence solenoid
Fig. 4-181
Fig. 4-182
e-STUDIO556/656/756/856/557/657/757/857
4 - 65
Tandem LCF
end fence motor
Side wall
DISASSEMBLY AND REPLACEMENT
4