Toshiba e-STUDIO556 Service Manual page 433

6.4.8 Adjustment of image density
The image density level can be set at the following codes.
e-STUDIO556/656/756/856
Text/
Text Photo
Photo
7212- 7213- 7214-
0 to 4 0 to 4 0 to 4
e-STUDIO557/657/757/857
Text/Photo Text
7212- 7213-
0 to 4 0 to 4
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in a code and press the [START] button.
(3) Key in the sub code and press the [START] button.
(4) Key in an adjustment value.
(To correct the keyed-in value, press the [C] button.)
(5) Press the [OK] or [INTERRUPT] button to store the value in memory. The equipment goes back
to the ready state.
(6) For resetting the value, repeat step (2) to (5).
(7) Press the [FAX] button and then the [START] button. Then perform test copying.
(8) If the image density has not been attained, repeat step (2) to (7).
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Color
Item to be
Docume
adjusted
nt
7215- Adjustment When the value is decreased, text becomes lighter.
0 to 4 of image Acceptable values: 0 to 255
density Default: sub code 0: 0, sub code 1: 63, sub code 2:
127, sub code 3: 191, sub code 4: 230 (05-7212/
7213), 255 (05-7214, 7215)
Item to be
Photo
adjusted
7214- Adjustment When the value is decreased, text becomes lighter.
0 to 4 of image Acceptable values: 0 to 255
density <e-STUDIO557/657>
Default:
sub code 0: 0
sub code 1: 32
sub code 2: 64
sub code 3: 96
sub code 4: 160
<e-STUDIO757/857>
Default:
sub code 0: 0
sub code 1: 32
sub code 2: 96
sub code 3: 144
sub code 4: 192
6 - 29
< Adjustment Mode (05) >
Contents
Notes:
• Set not to reverse the large and small
number of the setting value
corresponding to the sub code.
• Remember that the image specifications
and life span of the replacing parts may
not meet the standard when the setting
value is changed from the default value.
Contents
Notes:
• Set not to reverse the large and small
number of the setting value
corresponding to the sub code.
• Remember that the image specifications
and life span of the replacing parts may
not meet the standard when the setting
value is changed from the default value.
e-STUDIO556/656/756/856/557/657/757/857
6
ADJUSTMENT