Toshiba e-STUDIO556 Service Manual page 345

4.13.55 RADF board (RADF)
(1) Take off the RADF rear cover.
( P.4-136 "4.13.3 RADF rear cover")
(2) Remove 1 screw and take off the bracket[1].
(3) Take off the RADF rear cover.
( P.4-136 "4.13.3 RADF rear cover")
(4) Disconnect 11 connectors. Remove 4 screws
and take off the RADF board.
Note:
When replacing the RADF board, be sure to
perform the original reading start sensor
adjustment.
( P.6-80 "6.15.8 Original reading start
sensor adjustment")
4.13.56 RADF board bracket
(1) Take off the RADF rear cover.
( P.4-136 "4.13.3 RADF rear cover")
(2) Disconnect 11 connectors.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-514
Fig. 4-515
Fig. 4-516
e-STUDIO556/656/756/856/557/657/757/857
4 - 181
[1]
LED3
LED3
DISASSEMBLY AND REPLACEMENT
4