Toshiba e-STUDIO556 Service Manual page 471

6.14.4 High-fusing mode
When the fusing level needs to be raised, it can be set at the setting mode "08".
(1) Level up at 1st printing
Changing the setting of the pre-running time for first printing
The level is raised by delaying the time for the 1st printing and extending the time to warm the
fuser roller. At this code, the time to delay is set.
<Setting mode(08)>
Code
08-2053 First printing time with plain paper
08-2054 First printing time with thick paper 1
08-2055 First printing time with thick paper 2
08-2031 First printing time with thick paper 3
08-2052 First printing time with OHP
(2) Level up at continuous printing.
The level for the continuous printing is set at the "high-fusing mode (08-2147)". The level is
raised by delaying the printing cycle and controlling not to lower the fuser roller temperature.
The setting of 08-2147 is reflected when "Thick paper 3" is selected.
Note:
08-2031 of (1) and 08-2147 of (2) can be combined.
6.14.5 Changing Printing Speed
When the fuser roller temperature drops drastically during the continuous printing, the printing may be
stopped to increase the fuser roller temperature because the shortage in supply to the fuser unit,
depending of the use condition (use environment, power voltage condition, heat reserve condition of
the fuser unit).
To prevent the printing from stopping or to decrease its frequency, enable the setting of changing the
printing speed when the temperature drops, at the setting mode "08".
<Setting mode(08)>
Code
08-2242 Changing Printing Speed (Plain paper)
08-2243 Changing Printing Speed (Thick paper 1)
08-2244 Changing Printing Speed (Thick paper 2)
08-2245 Changing Printing Speed (Thick paper 3)
Notes:
1. When the setting value "1" is selected, the printing speed slows down if the fuser roller
temperature drops for only 5 minutes after the warming-up time.
2. When the setting value "2" is selected, the printing speed slows down if the fuser roller
temperature drops.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Contents
Contents
6 - 67
Default
0 0: Disabled, 1: Enabled only for 5min.
2: Always enabled
0 0:Disabled, 1: Enabled only for 5min.
2: Always enabled
0 0:Disabled, 1: Enabled only for 5min.
2: Always enabled
0 0:Disabled, 1: Enabled only for 5min.
2: Always enabled
e-STUDIO556/656/756/856/557/657/757/857
Values
ADJUSTMENT
6