Toshiba e-STUDIO556 Service Manual page 504

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO556:

The mode LED1~4 light OFF and the writing operation of the tray width adjustment data into the

EEPROM is finished.

* When the writing into the EEPROM has been finished, make sure to check the result with the

following table.

Writing result

Failure (minimum position)

Failure (maximum position)

Failure (both maximum) and minimum

Input check 1

This is a mode at which the checking of each motor, solenoid and clutch operation is carried out.

Turn ON the power with pressing the control panel mode key and start key. (The start LED blinks

Press the mode key and set up the LED1 to blink and LED2~4 to light OFF, and press the start

key. (The start LED lights ON in green.)

* With pressing the mode key for more than 1 sec., all the mode LEDs light OFF and become

able to be reset.

Press the mode key and check the operations referring to the following table. The operational

mode is switched at every time the mode key is pressed.

* Num (at the right table): the number of times which the key is pressed

* At the operational mode 7~36, the motor rotation speed is switched whenever the start key is

pressed. The motor rotation speed can be checked by referring to the mode LED blinking

Mode LED blinking at 1000msec. cycle: Low speed

Mode LED blinking at 700msec. cycle: Medium speed

Mode LED blinking at 500msec. cycle: High speed 1

Mode LED blinking at 250msec. cycle: High speed 2

Mode LED blinking at 100msec. cycle: High speed 3

Pickup trigger solenoid ON

Pickup trigger solenoid OFF

Pickup clutch ON

Pickup clutch OFF

Reverse solenoid ON

Reverse solenoid OFF

e-STUDIO556/656/756/856/557/657/757/857

Mode LED display