Toshiba e-STUDIO556 Service Manual page 171

(5) Take off the top right cove and right upper
cover.
( P.4-2 "4.1.3 Top right cover", P.4-3
"4.1.7 Right upper cover")
(6) Release the harness from the clamp.
(7) Remove 1 screw and take off the clamp.
(8) Remove 4 screws.
(9) Release the harness from the clamp and
then place the control panel unit with its
reverse side up.
Note:
When assembling the unit, be sure that the
harness is not caught.
(10) Remove 1 screw, take off 3 clamps and
disconnect 1 connector (with a lock).
(11) Remove 2 screws, take off a USB port and
then the control panel unit.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-18
[1]
Fig. 4-19
Fig. 4-20
e-STUDIO556/656/756/856/557/657/757/857
4 - 7
DISASSEMBLY AND REPLACEMENT
4