Toshiba e-STUDIO556 Service Manual page 266

4.10 Transfer/Transport Unit
4.10.1 Transfer unit
(1) Open the front cover and take out the
transfer/transport unit by turning the lever
clockwise.
(2) Remove 1 screw to take off the handle.
(3) Remove 2 screws to take off the cover.
(4) Disconnect 2 connectors. (Raise the belt
when disconnecting the connector on the
right side.)
(5) Remove 1 clip and slide the bearing on the
front side to inside.
(6) Remove 4 screws.
(7) Slide the transfer unit to the rear side and
raise the front side to take it off.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Screw
Screw
Bearing Clip
Screw
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 102
Transfer/transport unit
Fig. 4-285
Cover
Handle Screw
Fig. 4-286
Screw
Connector
Screw
Fig. 4-287