Toshiba e-STUDIO556 Service Manual page 259

(5) Remove the bearing, the E-ring, and then the
gear and the parallel pin.
(6) Remove 2 screws of the developer sleeve
holder on the rear side.
(7) Take off the upper and lower developer
sleeve with the holder.
(8) Remove 2 pole position fixing bushings, and
then 2 E-rings.
(9) Remove 4 E-rings and then 2 gears.
(10) Remove the developer sleeve holder on the
front and rear side.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Screw
Fig. 4-266
Pole position
fixing bushing
Fig. 4-267
Developer sleeve holder
Fig. 4-268
e-STUDIO556/656/756/856/557/657/757/857
4 - 95
Developer sleeve holder
Bearing, E-ring, Gear, Pin
Gear
DISASSEMBLY AND REPLACEMENT
4