Toshiba e-STUDIO556 Service Manual page 435

6.5 Image Quality Adjustment (Printing Function)
6.5.1 Adjustment of smudged/faint text
The smudged/faint text can be set at the following codes.
Language
PS PCL
7325 7326
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in a code and press the [START] button.
(3) Key in an adjustment value.
(To correct the keyed-in value, press the [C] button.)
(4) Press the [OK] or [INTERRUPT] button to store the value. The equipment goes back to the ready
state.
(5) Shut down (turn the power OFF), back ON, and then perform the printing job.
(6) If the desired text density has not been attained, repeat step (2) to (5).
6.5.2 Adjustment of image density
The image density level can be set at the following codes.
Toner save mode
General
PS PCL
7330 7331 7332
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in a code and press the [START] button.
(3) Key in an adjustment value.
(To correct the keyed-in value, press the [C] button.)
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
XPS
7327 When the value increases, the smudged text is improved. When the value
decreases, the faint text is improved.
Acceptable values: 0 to 9 (Default: 5)
Hardco
py Item to be
security adjusted
XPS
printing
7333 7334 Adjustment
of image
density
6 - 31
< Adjustment Mode (05) >
Remarks
< Adjustment Mode (05) >
Contents
When the value is decreased, text becomes
lighter.
Acceptable values: 0 to 255
<e-STUDIO556/656/756/856>
Default: 255 (7330, 7334), 176 (7331,
7332, 7333)
<e-STUDIO557/657>
Default: 160 (7330) , 96 (7331, 7332,
7333), 144 (7334)
<e-STUDIO757/857>
Default: 192 (7330), 128 (7331, 7332,
7333), 160 (7334)
Note:
Remember that the image
specifications and life span of the
replacing parts may not meet the
standard when the setting value is
changed from the default value.
e-STUDIO556/656/756/856/557/657/757/857
6
ADJUSTMENT