Toshiba e-STUDIO556 Service Manual page 312

(4) Remove 1 screw and take off the separation
roller holder [1]. Then take off the separation
roller unit.
Note:
Do not peel off the film [2] of the separation
roller holder since it is fixed to the RADF with
double-faced adhesive tape.
(5) Remove 1 E-ring and 1 bushing and then
take off the separation roller.
4.13.17 Separation roller
(1) Take off the RADF front cover.
( P.4-135 "4.13.2 RADF front cover")
(2) Take off the RADF rear cover.
( P.4-136 "4.13.3 RADF rear cover")
(3) Remove 4 screws and take off the feeder
upper guide unit [1].
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
(e-STUDIO557/657/757/857)
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 148
[1]
Fig. 4-416
Fig. 4-417
[1]
Fig. 4-418
[2]