[Procedure 2]
Is the safety zone switch (MS3) working normally?
NO
YES
Is the safety zone switch (MS3) correctly pressed?
NO
YES
Is the swing guide closed detection switch-2 (MS6) working normally?
NO
YES
Is the swing guide closed detection switch-2 (MS6) correctly pressed?
NO
YES
Replace the finisher controller PC board.
[Procedure 3]
Is the swing motor clock sensor (PI20) working normally?
NO
YES
MJ-1027/1028:
Does the voltage between J11-6 and -7 on the finisher controller PC board become 24V
when the swing motor starts rotating?
MJ-1029:
Does the voltage between J9-6 and -7 on the finisher controller PC board become 24V
when the swing motor starts rotating?
NO
YES
Is the wiring between the swing motor and finisher controller PC board correct?
YES Correct the wiring.
NO
Replace the swing motor.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Replace the switch.
Fix the mechanism.
Replace the switch.
Fix the mechanism.
Replace the sensor.
Replace the finisher controller PC board.
8 - 125
e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8