Toshiba e-STUDIO556 Service Manual page 297

4.12.11 Exit motor [M18]
(1) Take off the reverse section driving unit.
( P.4-131 "4.12.8 Reverse section driving
unit / Reverse motor driving PC board
(MOT2-RV board)")
(2) Take off the rear cover.
( P.4-5 "4.1.13 Rear cover")
(3) Take off the LGC board cover and disconnect
1 connector.
(4) Remove 2 screws and take off the exit motor.
4.12.12 O-ring
When installing the receiving tray, add the O-rings (service parts) to the exit roller in order to improve
the paper stacking condition.
(1) Remove 6 screws and take off the left lower
cover (exit cover).
( P.4-4 "4.1.11 Left lower cover (Exit
cover)")
(2) Remove 2 E-rings and move the 2 bearings
toward the inside.
(3) Move the exit roller to the near side and
install 2 O-rings to the grooves of the exit
roller.
Note:
O-ring: Refer to the parts list for the parts
number and so on.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-370
E-ring
Fig. 4-371
O-ring
Fig. 4-372
e-STUDIO556/656/756/856/557/657/757/857
4 - 133
Exit motor
Bearing
DISASSEMBLY AND REPLACEMENT
4