Toshiba e-STUDIO556 Service Manual page 370

HDD Assist Mode
Current HDD type: SATA HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
2. Remove key
Remark:
If the HDD type cannot be identified, "Unknown HDD" may appear on the screen.
Refer to  P.8-144 " [F106_1] ADI-HDD error: HDD type detection error"
Note:
When "SATA HDD" (normal HDD) is displayed, items 1 and 2 are not selectable. If you select any
of 1 and 2 and press the [START] button, the error message below appears.
HDD Assist Mode
Current HDD type: SATA HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
=>
2. Remove key
Operation Failed.
Press SoftPower Key to Switch Off
e-STUDIO556/656/756/856/557/657/757/857
SELF-DIAGNOSTIC MODE
System Firmware Version
Update Mode
Fig. 5-8
System Firmware Version
Update Mode
Fig. 5-9
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
5 - 20
: xxxx(x.x.x.x)
: 4c Mode
: xxxx(x.x.x.x)
: 4c Mode