Toshiba e-STUDIO556 Service Manual page 248

4.8.9 Drum motor (M11) / Motor driving PC board (MOT)
(1) Take off the rear cover, SYS board and then
hard disk with its bracket.
(2) Remove 3 screws to take off the drum wheel.
(3) Disconnect 1 connector and remove 3
screws to take off the drum motor with its
bracket.
Note:
When installing the drum motor, tighten the
screw while the bracket is pushed against
the motor in the direction of the arrow.
(4) Remove 3 screws to take off the drum motor.
4.8.10 Cleaning brush drive motor (M13) / Drum separation finger
solenoid (SOL1)
(1) Take off the exhaust duct.
( P.4-73 "4.7.6 Exhaust duct")
(2) Remove 1 screw and take off the stay.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Fig. 4-234
Drum motor
Screw
Fig. 4-235
Fig. 4-236
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 84
Drum wheel
Screw
Screw
Screw Connector
Stay