Toshiba e-STUDIO556 Service Manual page 825

(5) Remove 4 screws and take off the HDD and
the ground wire from the brackets.
(6) Remove 4 screws and take off the hard disk
[1].
9.1.8 Hard disk (HDD) (e-STUDIO557/657/757/857)
(1) Take off the rear cover.
( P.4-5 "4.1.13 Rear cover")
(2) Remove the SYS board cover.
( P.9-1 "9.1.1 SYS board cover")
(3) Disconnect 1 connectors and remove 1
screw to take off the ground wire.
(4) Remove 4 screws and remove 4 washers to
take off the HDD with its bracket.
Note:
Be sure that any vibration is not transmitted
to the HDD.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
HDD
Fig. 9-18
[ 1 ]
Fig. 9-19
Fig. 9-20
e-STUDIO556/656/756/856/557/657/757/857
REPLACEMENT OF PC BOARDS / HDD
9 - 7
Bracket
HDD
9