Toshiba e-STUDIO556 Service Manual page 538

* 14. Whole toner recycle unit
Clean up the toner in the toner recycle unit when replacing the developer material.
(1) Take off the toner recycle unit.
(2) Remove 3 screws to separate the recycle
toner hopper and the auger pipe.
(3) Vacuum off the toner inside and the supply
section of the recycle toner hopper.
(4) Remove 1 screw and take off the cover of the
supply opening.
(5) Vacuum off the toner in the auger section.
Note:
When cleaning the auger section with a
vacuum cleaner, be sure to ground the motor
bracket to prevent the motor from being
damaged by static electricity.
e-STUDIO556/656/756/856/557/657/757/857
PREVENTIVE MAINTENANCE (PM)
Toner recycle unit
Recycle toner hopper
Cover
Connected to earth
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
7 - 28
Fig. 7-23
Supply section
Fig. 7-24
Auger section
Fig. 7-25
Fig. 7-26