Toshiba e-STUDIO556 Service Manual page 251

4.9.3 New toner supply motor (M5)
(1) Remove 3 screws to take off the top cover.
(2) Disconnect 1 connector, remove 2 screws,
and then take off the new toner supply motor.
Note:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
4.9.4 Toner cartridge empty sensor (S10)
(1) Remove 2 screws, and then take off the
toner cartridge empty sensor with the
harness.
(2) Disconnect 1 connector from the toner
cartridge empty sensor.
Note:
Be careful not to damage the sensor when
connecting and disconnecting the connector.
4.9.5 New toner transport motor (M6)
(1) Remove 3 screws to take off the top cover.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
New toner supply motor
Fig. 4-242
Toner cartridge empty sensor
Fig. 4-243
Top cover
Screw
Fig. 4-244
e-STUDIO556/656/756/856/557/657/757/857
4 - 87
Screw
Connector
Screw
DISASSEMBLY AND REPLACEMENT
4