Toshiba e-STUDIO556 Service Manual page 453

6.9 Adjustment of the Scanner Section
6.9.1 Adjustment carriages-1 and -2 positions
<Procedure>
(1) Take off the RADF.
(2) Take off the original glass.
(3) Take off the top right cover.
(4) Take off the top rear cover.
(5) Move the carriage-2 toward the exit side.
Note:
Rotate the drive pulley to move the carriage.
(6) Loosen the screws fixing the front side pulley
bracket, make the sections A and B of the
carriage-2 touch with the inside of the exit
side frame and screw them up.
Note:
Make sure that the sections A and B of the
carriage-2 touch with the exit side frame.
(7) Put carriage-1 on the rail. Then make
sections C and D of carriage-1 touch the
inside of the exit side frame and tighten the
front and rear sides of the bracket with the
screws.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Carriage-2
[ Rear ]
Exit side frame
B
Fig. 6-28
Bracket
Carriage-1
D
[ Rear ]
Enlarged view of carriage
Fig. 6-29
e-STUDIO556/656/756/856/557/657/757/857
6 - 49
Pulley bracket
[Front]
A
Enlarged view of carriage
Bracket
Exit frame
C
[ Front ]
ADJUSTMENT
6