Toshiba e-STUDIO556 Service Manual page 276

(4) Remove 1 screw to take off the transfer belt
release detection sensor (S15).
(5) Remove 1 screw to take off the transfer belt
contact detection sensor (S16).
4.10.13 Transfer belt cam motor (M15)
(1) Take off the transfer belt contact/release cam
driving unit.
( P.4-111 "4.10.12 Transfer belt contact/
release cam driving unit")
(2) Remove 2 screws and disconnect 1
connector to take off the transfer belt cam
motor.
Note:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Transfer belt release
detection sensor
Transfer belt cam motor
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 112
Transfer belt contact
detection sensor
Fig. 4-314
Fig. 4-315