Toshiba e-STUDIO556 Service Manual page 178

(6) Remove the square seal fixing the lamp
harness to the base. Disconnect the
connector of the lamp harness from the SLG
board
Notes:
Be sure to install the lamp harness by
following the procedure below.
1. Using alcohol, clean the area where the
seal is to be attached.
2. Align the black line on the lamp harness
with the position as shown in the figure,
and fix it with a seal.
3. Align the bent portion of the lamp harness
with the position as shown in the figure,
and fix it with a seal.
4. After the installation, move carriage-1
towards the left and confirm that there is
no abnormality in the lamp harness, such
as twisting.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Connector
Lamp harness
Black Line
Hole
Punched mark
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 14
Seal
Fig. 4-37
Lamp harness
Seal
Fig. 4-38
Lamp harness
Seal
Punched mark
Fig. 4-39