Toshiba e-STUDIO556 Service Manual page 695

[F102] HDD boot error
[F103] HDD transfer time-out
[F104] HDD data error
[F105] other HDD error
Classification
Other service call
Check item
HDD
Replace parts
HDD
SYS board
[F106_0] ADI-HDD error: Illegal disk replacement detected (ADI-HDD Exchange to SATA-HDD)
Classification
Other service call
Check item
Setting
HDD
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
HDD start error: HDD cannot become "Ready" state.
HDD transfer time-out: Reading/writing cannot be performed in the
specified period of time.
HDD data error: Abnormality is detected in the data of HDD.
HDD other error
• Connector and harness check
• Check if the connector pins of the HDD are bent.
• Perform the bad sector check (08-9072). If the check result is OK,
recover the data in the HDD. If the check result is failed, replace the
HDD.
ADI-HDD error: The ADI-HDD has been replaced illegally to SATA-HDD
(normal type).
Check if the HDD has been replaced with a SATA-HDD (normal type).
1. Start the equipment in the 4C mode: [4] + [C] + [POWER])
2. Check the type of the HDD shown on the top left of the control panel
display "Current HDD type".
2a. In case of "SATA-HDD" (normal type), replace it with the original ADI-
HDD or a new ADI-HDD.
Note:
To replace with the original ADI-HDD, start the equipment in the
normal mode and then reinstall master data (HD Data) only if any
abnormality occurs.
2b. In case of "ADI-HDD"
• Check each item in the Measures field for the HDD.below
If the error still occurs, reinstall the master data (HD Data).
• Connector check
• Harness check
Follow the procedure below if no abnormality is found in the check items
above.
1. Start the equipment in the 4C mode: [4] + [C] + [POWER] →
1. Revert factory initial status HDD
2. Reinstall the system software.
8 - 143
Error item
Measures
Remarks
Error item
Measures
e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8