Toshiba e-STUDIO556 Service Manual page 280

(6) Remove 1 screw, move the fuser unit
forward and lift it off upward.
Notes:
1. When installing or taking off the fuser unit,
grab the section "A" in the figure.
2. Be sure that the temperature of the fuser
unit has lowered enough before taking it
off. If the unit still heated should be taken
off, wear a pair of gloves before working.
3. Hold B sections of the fuser unit when
installing/removing it.
Note:
How to identify between the fuser unit of e-STUDIO557 and e-STUDIO657/757/857
Be careful not to install the wrong bracket because its shape differs between e-STUDIO557 and
e-STUDIO657/757/857.
• The position of the fuser unit installation screw is different.
• Engraved identification mark:
e-STUDIO557: 55
e-STUDIO657/757/857: 85
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
55
55
e-STUDIO557
Fig. 4-324
4 - 116
B
Fig. 4-323
85
85
e-STUDIO657/757/857
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
A
Screw