Toshiba e-STUDIO556 Service Manual page 235

(5) Disconnect 2 connectors, remove 1 screw,
and then take off the wire cleaner position
detection switch (SW4).
Note:
Push the switch in the direction of arrow A to
fix it. Also, carefully insert the connector into
the terminal of the color of the harness, and
then bend the terminal 45 º.
4.7.3 Discharge LED (ERS)
(1) Take off the wire cleaner drive unit.
( P.4-70 "4.7.2 Wire cleaner drive unit /
Wire cleaner drive motor (M12)")
(2) Disconnect 1 connector.
(3) Lift the connector side of the discharge LED
slightly to release the lock, and then slowly
pull out the discharge LED from the guide.
Note:
Assemble the discharge LED so that all
fingers of the guide are hooked.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Black Purple Connector
Fig. 4-197
Fig. 4-198
Latch
Discharge LED
Fig. 4-199
e-STUDIO556/656/756/856/557/657/757/857
4 - 71
Screw
( A )
Connector
Lock pin
Discharge LED
DISASSEMBLY AND REPLACEMENT
4