Toshiba e-STUDIO556 Service Manual page 936

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO556:

After the update is completed properly, the LED on the download jig blinks.

The LED starts blinking approx. 20 sec. after the update starts. It is assumed that the update has

failed if it does not start blinking even though 1 min. has passed. In this case, shut down the

equipment and check the following items. Then clear the problems and restart updating from the

Is the download jig connected properly?

Is the ROM installed to the download jig properly?

Is the updating data written on the ROM of the download jig properly?

Do the download jig and the equipment operate properly?

Press the [ON/OFF] button on the control panel to shut down the equipment.

Remove the download jig and install the connector cover.

(10) Close the front cover.

[B] Confirmation of the updated data

After the updating is completed, check each data version in Setting Mode (08) to confirm that the data

were overwritten properly.

 P.11-62 "11.7 Confirmation of the updated data"

e-STUDIO556/656/756/856/557/657/757/857

FIRMWARE UPDATING