(6)
After the update is completed properly, the LED on the download jig blinks (at an interval of
approx. 1 sec.).
The LED starts blinking approx. 50 sec. after the update starts. It is assumed that the update has
failed if it does not start blinking even though 2 min. has passed. In this case, shut down the
equipment and check the following items. Then clear the problems and restart updating from the
beginning.
•
Is the download jig connected properly?
•
Is the ROM installed to the download jig properly?
•
Is the updating data written on the ROM of the download jig properly?
•
Do the download jig, RADF and the equipment operate properly?
(7)
Press the [ON/OFF] button on the control panel to shut down the equipment.
(8)
Remove the download jig and install the RADF rear cover.
[B] Confirmation of the updated data
After the updating is completed, check each data version in Setting Mode (08) to confirm that the data
were overwritten properly.
P.11-62 "11.7 Confirmation of the updated data"
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO556/656/756/856/557/657/757/857
11 - 51
FIRMWARE UPDATING
11