[Procedure 3]
Is the paper pushing plate motor clock sensor (PI1S) working normally?
NO
YES
Is the paper pushing plate motor (M8S) operating at the fixed timing?
YES Replace the saddle stitcher controller PC board.
NO
Is there any problem with the pushing plate drive mechanism?
YES Fix the mechanism.
NO
Is the problem solved by replacing the paper pushing plate motor (M8S)?
NO
YES
END
[CBA0] Stitch motor (front) abnormality
[CBB0] Stitch motor (rear) abnormality
Are the front and rear stitchers and their stands installed properly?
NO
YES
Are the stitcher home position switches (MS7S/MS5S) on the front and rear stitchers
working normally?
NO
YES
Are the front and rear stitchers operating at the fixed timing?
NO
YES
Check the wiring between the stitcher and saddle stitcher controller PC board. If there is no
problem, replace the controller PC board.
e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
Replace the sensor.
Replace the saddle stitcher controller PC board.
Install them properly.
Replace the front or rear stitcher.
Replace the front or rear stitcher.
8 - 118
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved