Toshiba e-STUDIO556 Service Manual page 851

(4) Perform "Destination display at SRAM initialization" (08-9060).
(5) Check whether the displayed destination (see the below figure) of the SYS-SRAM board is the
same as the one in step (1).
Note:
If the destination for the SYS-SRAM board and the one checked in step (1) is not the same,
initialize the SYS-SRAM board referring the following.
 P.9-27 "9.2.7 Precautions and Procedures when replacing SRAM board"
(6) Perform "Printer all clear" (08-9090).
(7) Press [INITIALIZE] to initialize the NVRAM.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 9-38
e-STUDIO556/656/756/856/557/657/757/857
9 - 33
REPLACEMENT OF PC BOARDS / HDD
9