Xerox VersaLink B7025 Service Manual page 1328

Figure 21 Closer view
Product Technical Overview
Tamper Assemblies
The tamper assemblies are used to compile sets of paper into registered stacks either for sta-
pling or exit to the stacker tray. The tamper assemblies tamp the sets of paper to the front, cen-
ter, or rear of the compiler, as required.
The Finisher LX has two separate tamper assemblies which operate as a single unit. These
are the front and rear tamper assemblies. Each tamper assembly consists of a tamping paddle,
tamper paddle motor, and a tamper home sensor. Refer to
Front tamper
home sensor
Rear tamper
motor
Figure 22 Tamper assemblies
April 2017
8-82 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
Figure 22.
Front tamping paddle
Front tamper motor
Rear tamp-
ing paddle
Rear tamper
home sensor
Launch Issue