Rep 2.0.14 Y-Axis Spring; Rep 2.0.15 Transfix Load Module - Xerox Phaser 8560MFP Service Documentation

REP 2.0.14 Y-Axis Spring

Parts List on PL 2.0
Removal
1. Remove the Scanner Assembly and Attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Left Side Cover (REP 1.0.7).
4. Release tension on the Y-Axis Belt by pulling the end of the Spring Arm toward the front of
the printer. Remove the belt from the Drum Pulley, then the motor.
Figure 1 Removing the Y-Axis Spring
5. Remove the Y-Axis Spring using either a spring hook or pliers, Brace the printer to prevent
movement while removing the spring.
Repairs and Adjustments
REP 2.0.14, REP 2.0.15

REP 2.0.15 Transfix Load Module

Parts List on PL 2.0
Removal
1. Remove the Scanner Assembly and attached DADF (REP 1.0.11).
2. Remove the Front Door (REP 1.0.1).
3. Remove the Ink Loader (REP 2.0.1).
4. Remove the Preheater (REP 2.0.17).
5. Remove the Outer Duplex Guide (REP 3.0.6).
6. Remove the Media Drive Assembly (REP 4.0.14).
7. Remove the Exit Module (REP 3.0.7).
8. Remove the Duplex Roller (REP 3.0.4).
9. Remove the Upper Duplex Guide and Solenoid (REP 3.0.5).
10. Insert a T-20 Torx bit through the right side slotted hole in the Transfix Load Module.
Engage the hole at the back of the module, and lever the module's spring cam towards
the center of the printer while disconnecting the spring hooks from the Transfix Load
Arms. Repeat this process for the left side.
Figure 1 Detaching the Transfix Load Module Spring Hooks
NOTE: In the following step, the Media Release Blade, Transfix Roller, Transfix Roller
Shaft, and the 2 Transfix Load Arms are removed as a single assembly.
11. Remove the Clevis Pins from the left and right Transfix Load Arms to release the Transfix
Roller assembly from the chassis.
10/2006
4-32
Initial Issue
Phaser 8510/8560MFP Multifunction Product