Drum; Procedure Of Parts Replacement - Canon imageRUNNER ADVANCE 8105 Series Service Manual

2
Technology > Image Formation System > Servicing > When Replacing Parts
●

Drum

<Procedure of parts replacement>
see "Removing the Photosensitive Drum," on p. 4-122.
<Procedure of adjustment>
1) Clear the parts counter. (COPIER>COUNTER>DRBL-1>PT-DRM)
2) Replace the ROM connected to the host machine with the drum ROM included in the drum.
MEMO:
If the ROM is not replaced, the replaced drum and the drum-unique data stored
in the ROM data are not matched. As a result, when the 2D shading function is
enabled, it is not functioned normally.
2-1) Remove the Drum EEROM.
• 1 Screw
•
1 Connector
2
Technology > Image Formation System > Servicing > When Replacing Parts
3) Affix the ID Label included in the drum to the inside of the Front Cover.
4) Activate the drum replacement mode. (COPIER>FUNCTION>INSTALL>DRM-INIT)
5) Check the 2-dimensional shading ROM. (COPIER>FUNCTION>2D-SHADE>2D-READ)
F-2-117 F-2-117
2-92
F-2-118 F-2-118
2-92