Note For Customers Who Cut Their Own Paper; Media Sizes And Feed Location Chart - Canon imagePRESS V1000 Customer Expectation Document

Canon

15.6 Note for Customers Who Cut Their Own Paper

Customers who cut their own paper may experience:
• An increase of paper dust in the machine
• Shortening the life of the machine's fixing rollers due to excessive wear from the
rough side of the cut paper
• Paper jams due to paper dust getting into areas of the machine where it is not
meant to be
• Improper paper feeding
• Paper registration inaccuracies
Follow the precautions below to minimize the above issues:
• Have a process in place to regularly make sure that the cutting blades are
sharpened, and that cuts are made as clean as possible.
• Place the paper with the factory mill cut sides facing to the right (leading edge),
and to the front of the machine.
• Pay special attention to the paper grain orientation when cutting it. For more
information on paper grain, see
• The best results for consistency and front to back registration are obtained by using
factory mill cut, digital compatible paper.

15.7 Media Sizes and Feed Location Chart

As with all Canon copiers, certain feed locations within the device are capable of
feeding specific media sizes, types, and weights.
When considering media, make sure the media is within the proper size and weight
parameters of the feed location. Once the desired media is selected, select the
appropriate feed location.
Revision 4
"Paper Grain and Curl,"
imagePRESS V1000 Customer Expectations Document
imagePRESS V1000 Customer Expectations Document
on p. 120.
Page 121