Service Call Button Setting Items; Service Browser Setting Items; Steps To E-Rds Settings - Canon imageRUNNER ADVANCE 8105 Series Service Manual

2
Technology > Embedded RDS > E-RDS Setup > Steps to E-RDS settings
●

SERVICE CALL BUTTON setting items

Item
SCALL-SW Display/hide of repair request button
([Lv.1] COPIER > Option > USER) 0: Hide / 1: Display
To set whether to display or hide the repair-request button
on the Control Panel.
Default : 0 (Hide)
SCALLCMP Set of repair request complete notice
([Lv.1] COPIER > Option > USER) When this item is set (when [OK] is touched regardless of
whether 0 or 1 is set), service call completion is notified
to UGW and the service call status retained internally is
cleared.
Default : 0
●

SERVICE BROWSER setting items

Item
BRWS-ACT Execution of activation / inactivation of service browsing
([Lv.1] COPIER > Function > INSTALL) Browsing info is sent to UGW when OFF (BRWS-ACT=0)
is changed to ACTIVE.
Setting result is displayed as "OK!" or "NG!".
BRWS-STS Display of Service Browser use status
([Lv.1] COPIER > Display > USER) 0: OFF / 1: Active / 2: Suspend
Default : 0 (OFF)
MEMO:
Generally, once service browsing is enabled, it cannot be disabled again.
To disable service browsing, clear SRAM.
2
Technology > Embedded RDS > E-RDS Setup > Steps to E-RDS settings
Description
T-2-115 T-2-115
Description
T-2-116 T-2-116
■

Steps to E-RDS settings

1. Start [Service Mode] at Level 1.
1) Press [Settings/Registration (User Mode)] button on the control panel.
2) Press [2] and [8] buttons at a time on the control panel.
3) Press [Settings/Registration (User Mode)] button on the control panel.
4) [Service Mode] screen is shown. Touch the [Mode List] button.
MEMO:
When [Mode List] is selected, touching the
the screen displays explanation of each item or detailed operation guide.
In case of [Mode List Classic], this button is not appeared.
2-225
F-2-318 F-2-318
button at the center of the lower side of
F-2-319 F-2-319
2-225