Table of Contents
Advertisement
Bits 6 to 4—Standby Timer Select (STS2 to STS0): These bits select the length of time the CPU
and on-chip supporting modules wait for the internal clock oscillator to settle when software
www.DataSheet4U.com
standby mode is exited by an external interrupt. When using a crystal oscillator, set these bits so
that the waiting time will be at least 7 ms at the system clock rate. For further information about
waiting time selection, see section 20.4.3, Selection of Waiting Time for Exit from Software
Standby Mode.
Bit 6
Bit 5
STS2
STS1
0
0
0
0
0
1
0
1
1
0
1
0
1
1
Bit 3—User Bit Enable (UE): Selects whether to use the UI bit in the condition code register as a
user bit or an interrupt mask bit.
Bit 3
UE
Description
0
UI bit in CCR is used as an interrupt mask bit
1
UI bit in CCR is used as a user bit
Bit 2—NMI Edge Select (NMIEG): Selects the valid edge of the NMI input.
Bit 2
NMIEG
Description
0
An interrupt is requested at the falling edge of NMI
1
An interrupt is requested at the rising edge of NMI
Bit 1—Reserved: Read-only bit, always read as 1.
Bit 0—RAM Enable (RAME): Enables or disables the on-chip RAM. The RAME bit is
initialized by the rising edge of the RES signal. It is not initialized in software standby mode.
Bit 0
RAME
Description
0
On-chip RAM is disabled
1
On-chip RAM is enabled
Bit 4
STS0
Description
0
Waiting time = 8,192 states
1
Waiting time = 16,384 states
0
Waiting time = 32,768 states
1
Waiting time = 65,536 states
0
Waiting time = 131,072 states
1
Waiting time = 1,024 states
—
Illegal setting
59
(Initial value)
(Initial value)
(Initial value)
(Initial value)
Advertisement
Table of Contents
