Hitachi H8/3048 Hardware Manual page 168

Bit 6—Compare Match Interrupt Enable (CMIE): Enables or disables the CMI interrupt
requested when the CMF flag is set to 1 in RTMCSR. The CMIE bit is always cleared to 0 when
www.DataSheet4U.com
PSRAME = 1 or DRAME = 1.
Bit 6
CMIE Description
0 The CMI interrupt requested by CMF is disabled
1 The CMI interrupt requested by CMF is enabled
Bits 5 to 3—Clock Select 2 to 0 (CKS2 to CKS0): These bits select an internal clock source for
input to RTCNT. When used for refresh control, the refresh controller outputs a refresh request at
periodic intervals determined by compare match between RTCNT and RTCOR. When used as an
interval timer, the refresh controller generates CMI interrupts at periodic intervals determined by
compare match. These bits are write-disabled when the PSRAME bit or DRAME bit is set to 1.
Bit 5 Bit 4 Bit 3
CKS2 CKS1 CKS0
0 0 0
1
1 0
1
1 0 0
1
1 0
1
Bits 2 to 0—Reserved: Read-only bits, always read as 1.
Description
Clock input is disabled
ø/2 clock source
ø/8 clock source
ø/32 clock source
ø/128 clock source
ø/512 clock source
ø/2048 clock source
ø/4096 clock source
154
(Initial value)
(Initial value)