Patient Positioning Panel; Status Indicator Light - KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual

4 User Interfaces

4.2 Patient positioning panel

1. Carriage up/down slider. The carriage can be driven up and down by sliding a
finger on the carriage up/down slider. The speed of the carriage movement depends
on the distance the finger is moved. For faster carriage speed, start from the upper/
lower edge of the slider.
2. Test mode button. Disables radiation production of the device. You can also use the
GUI to activate the Test mode.
3. Patient positioning lights button. Turns the patient positioning lights on/off.
4. HOME button. Drives the rotating unit to HOME (Patient-In) and scan start
positions. Pressing the HOME button also wakes the device from Power save mode.
5. Exposure indicator (YELLOW). Device is radiating.
6. Status indicator (BLUE). Device is in error state or pending user action. Check the
GUI for details.
7. Ready indicator (GREEN). Device is ready for imaging.
NOTICE! If carriage up/down slider backlight is not illuminated, the carriage up/
down slider is in safe mode and cannot be used. Wait until the light comes back on
or wipe the panel clean if it is dirty.

4.3 Status indicator light

Device status indicator light, located on the top of the carriage, illuminates according the
device status:
• YELLOW: Device is generating X-rays.
• BLUE: Device is in error state or pending user action. Check the GUI for details.
• GREEN: Device is ready for imaging.
38
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
ORTHOPANTOMOGRAPH
D519207, 19
™
OP 3D