KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual page 114

9 Installation
6. Attach the exposure switch holder to the column or other metallic surface using its
built in magnets or screw it to a non-magnetic surface.
Magnetic surface installation
Proceed to chapter
communication link to the workstation.
114
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
Communication link configuration
Screw installation
1. Pull the rear cover of the holder off.
2. Screw the rear cover to the desired
surface.
3. Re-attach the holder to the rear
cover.
on page 115 and configure the
ORTHOPANTOMOGRAPH
™
OP 3D
D519207, 19