10. Lift the carriage locking bolts (3 pcs) up and tighten them to 25 Nm torque to secure
the carriage.
CAUTION! The carriage may fall down during use, if the carriage locking
bolts are not properly installed and tightened.
11. Detach the plywood cover from the right hand side first by removing all 7 indicated
screws and pulling it off.
NOTICE! Support the plywood cover when detaching the last screw to
prevent it from falling down.
ORTHOPANTOMOGRAPH
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
™
OP 3D
9 Installation
99
D519207, 19