Disposal And Recycling; Warnings And Requirements; Warnings And Precautions For Use - KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual

Hide thumbs Also See for ORTHOPANTOMOGRAPH OP 3D:
Table of Contents

Advertisement

2 Introduction

2.7 Disposal and recycling

The device and its components are lead-free, including its radiation protection
components. The device meets the RoHS Directive 2011/65/EU, WITHOUT any
exemptions mentioned in Annex IV. Dispose of the device, accessories and consumables
according to local requirements.
At least the following parts of the device should be re-cycled according to local and
national regulations regarding disposal of non-environmentally friendly materials:
• Tubehead (oil)
• All electronic circuits and electronic boards
• Plastic parts

2.8 Warnings and requirements

2.8.1 Warnings and precautions for use

• Before using the device for the first time, familiarize yourself with this manual to
ensure the safe use of the device.
• Before using the device for the first time, ensure that it has been set up according to
your requirements.
• This device complies with the EMC (Electromagnetic Compatibility) according to IEC
60601-1-2. Radio transmitting equipment, cellular phones etc. shall not be used in
proximity of the device as they could influence the performance of the device.
• Do not move the upper shelf of the device by hand as it may hit a wall or cause the
device to go to an error state.
• Avoid taking X-ray images of pregnant women.
• If the patient is using a pacemaker, consult the manufacturer of the pacemaker before
taking an X-ray image to confirm that the device will not interfere with the operation
of the pacemaker.
• Use the pediatric programs always when taking X-ray images of pediatric patients and
where feasible, adjust the radiation field size.
• Where it is likely that evaluation of soft tissues will be required as part of the patient's
radiological assessment, the imaging should be done using conventional medical CT or
MR, rather than 3D imaging using Cone Beam technology.
• Always ensure the patient positioning before taking X-ray images to diminish the need
for retakes.
• Always ask the patient to remain still for the duration of the exposure to diminish the
need for retakes.
• Follow the ALARA (As Low As Reasonably Achievable) principle and always seek to
reduce the radiation dose.
• When taking an X-ray image, protect yourself from radiation or stand at least 3
meters (9.8 ft) away from the device.
• When taking an X-ray image of a patient who is feeling insecure or has exceptional
anatomy (typically very tall or large patient) use the Test-mode first to demonstrate
10
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
ORTHOPANTOMOGRAPH
D519207, 19
OP 3D

Advertisement

Table of Contents
loading

Table of Contents