Device Modifications - KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual

2 Introduction
• Additional multiple socket-outlets or extension cords shall not be connected to the
system.
• The device must be connected to a private, firewall protected LAN network.
• Connecting the device to an IT-network that includes other equipment or changing the
IT-network can cause unidentified risks to patients or operators. It is the responsibility
of the organization controlling the IT-network to identify, analyze, evaluate and
control these possible risks.

2.8.4 Device modifications

CAUTION! The device does not contain user serviceable parts. Only authorized
service technicians are allowed to service, install and replace parts of the device.
CAUTION! Only approved spareparts supplied by the manufacturer are allowed
to be used in device service.
• Never make unauthorized changes or modifications to the device or any of its parts.
• Never remove or remanufacture any part of the tubehead assembly or beam limiting
devices.
• Never adjust any part of the beam limiting devices unless under the direction of the
manufacturer.
• All required information on the device service and part replacement is found in the
Service Manual, which is available for authorized service technicians.
12
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
ORTHOPANTOMOGRAPH
D519207, 19
™
OP 3D