3D Sensor Height Adjustment - KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual

9 Installation
3. Re-install the detached covers.
NOTICE! When re-installing the PAN/3D tubehead rear cover you must first
remove the tubehead plate from the PAN/3D tubehead rear cover.
9.11.4 2D/3D Sensor height adjustment
If the device geometry calibration has failed due to the sensor being too high/low the
height adjustment is required.
NOTICE! This adjustment is required only in special cases.
1. Pull the left and right 2D/3D sensor collar cover halves downwards.
2. Pull the right side collar cover half downwards to unlock the teeth holding the covers
together.
3. Pull the collar cover halves apart.
180
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
ORTHOPANTOMOGRAPH
D519207, 19
™
OP 3D