KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual page 100

9 Installation
12. Support the left hand side plywood cover by hand and detach the 4 indicated screws
on the plywood cover and pull it carefully off with the metal supports attached.
NOTICE! Support the plywood cover when detaching the last screw to
prevent it from falling down.
NOTICE! Be careful not to scratch the unit with the metal supports attached
to the plywood cover.
13. Detach the plywood top cover and the metal supports on top of the carriage (4
screws).
14. Remove the metal support from the rear of the carriage (4 screws).
100
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
ORTHOPANTOMOGRAPH
D519207, 19
™
OP 3D